75 Miles From Dickinson, ND

Customize your Search Radius & Location

Automobiles113

More Links

Hire It HauledFree / Giveaway ItemsPet GiveawaysWant AdsTradingStores & Dealers

My Links

Saved Searches0 Watch List0 Recently Viewed0

Mechanical Part

110 Results
BKH
2024-01-03 08:18:10
2002 Volkswagen 1.8 turbo engine. Engine has been professionally remaned. It has p
erformance pistons and rods. It is a balanced rotating assembly, has a performance intake, and comes completely assembled,
New England, ND
$5,000  OBO
alaskabnd
2024-01-02 00:44:59
3 Photos
Volkswagen type 3 dual port Holley bug spray 2 bbl carb manifold , $150
Killdeer, ND
$100
Kyle
2023-12-27 12:38:37
2 Photos
5.9L 24 Valve Cummins Head ('98 - '02)
Came off a 1999 5.9L Cummins Block No wear or tear on Head. No visible cracks or bad valves. 217k miles on Head It will need to be Decked by a Machinist.
Richardton, ND
$450  OBO
Jo
2023-12-27 02:16:51
2 Photos
Honda GX270 Engine in Excellent Used Condition
300 firm 701-260-5420
Hebron, ND
$300
BKH
2023-12-16 07:14:36
2 Photos
MASTER CYLINDER FOR A LATE 70'S DATSUN PICKUP.
New England, ND
Make an Offer
BKH
2023-12-16 07:14:24
3 Photos
New in the box connecting rods. These are Maxspeeding performance rods. They come
with Arp bolts and pin bushings. They are roughly a 18mm pin and 40mm bottom. Bought for a project that did not get
New England, ND
$250
BKH
2023-12-16 07:14:35
Custom made headers for a 60 series Ford flat head V8.
The pipes can be shortened, they were for another project that they did not get used on.
New England, ND
$200
BKH
2023-12-16 07:14:27
Honda remaned engine...ready to install!!!
Early 80's Honda engine.It is a completely remaned.Engine has all new internal parts.It also has a new cylinder head.Its complete with everything on it.Also have the clutch,alternator,starter, and
New England, ND
$750
alaskabnd
2023-12-02 15:49:00
3 Photos
Chrome spoked wheels off 1997 cadillac seville sts sedan , tires are dry rot wheel
s clean up nice , not bent , asking $300 for the set of 4
Killdeer, ND
$300
Sam
2023-11-19 11:13:48
Turbo
Dickinson, ND
$200
Casey
2023-11-18 08:41:03
3 Photos
73 chevy impala new gas tank and sender.
Less then 10 gallons ran though it. Cash only.
Hazen, ND
$225
Casey
2023-11-18 08:40:40
3 Photos
1990 K1500 Front Drive Shaft Chevy GM
Used drive shaft from 1990 Chevy K1500 with 700r4 and 241 C transfer case. Splines have some play but not bad. U-joints feel good. Cash only located in
Hazen, ND
$100
Jeff
2023-11-13 00:35:17
3 Photos
DANA 44 GEAR SET 4.10 GEAR RATIO
In very nice condition. From the front of a 70's Chevy 4X4, Will fit most any Dana 44 axle that has the fine spline yoke.
Hazen, ND
$50
02 Chevy
2023-10-17 22:10:44
auto tranny for 02 jeep
good used tranny came out of a 02 jeep grand cherokee 4x4
New England, ND
Make an Offer
Bob
2023-07-24 11:32:41
3 Photos
Front leaf springs 1995 f250
I replaced my front leaf springs because I thought they had too much bow in them but after putting the new ones on I think that is they way they are supposed to be.
Watford City, ND
$150
jethro2996
2023-05-12 16:59:32
Chevy 230/250 engine.
Pulled from a 1964 Chevy 1/2 ton I have heard it run but mileage and condition is unknown
Hettinger, ND
$350  OBO
BDU
2023-04-08 14:56:34
3 Photos
32 inch Hopkins 4 flat trailer wiring extension new never opened
Hazen, ND
$10
BDU
2023-04-07 18:14:48
Felpro exhaust flange gasket kit and peg board great assortment
Hazen, ND
$50
Swift
2023-04-05 17:59:02
Looking for '95 or newer GM 6.5 engine
I'm looking for a 6.5 GM engine that's '95 or newer with low miles if at all possible
Richardton, ND
Nova SS
2022-10-23 00:20:23
3 Photos
Ford Flathead
It came out of a 1951 ford car. It needs to be rebuilt. It is tight $250 Bell housing not included obo located in beulah
Beulah, ND
$250  OBO
110 Ads | Page 4 of 4 | Jump to Page: