Mechanical Part

73-87 Chevy 6 RC rear springs

73-87 Chevy 6 inch RC rear lift springs Brand new C10-20 K10-20 52 rear lift springs.

Parts & Accessories - Dickinson, ND

$325

2024-09-28 17:08:07

New Cobb battery tie down for Subaru wrx/sti.

$40 OBO. New Cobb battery tie down for Subaru wrx/sti. Billet aluminum and anodized blue.

Parts & Accessories - Dickinson, ND

$40 OBO

2024-09-25 14:52:34

6 Photos

Blue 07 Ram 2500, Red 06 Ram 2500. No motors, no transmissions, no titles, parts t

rucks. Selling as a pair, not part by part. The only question Ill answer is when can I look at them. $1800.

Parts & Accessories - North Almont, ND

$1,800 OBO

2024-09-24 19:35:17

Chevy 6 inch all spring lift

Make an offer All spring lift for squarebody Chevy k20's, 56 inch rear springs, not 52 like a k10. Just the springs. What I believe to be a 6 inch lift, unsure

Parts & Accessories - Dickinson, ND

$250

2024-09-07 07:49:39

BBC Cylinder Heads Casting numbers 14092360

I got a used set of bbc cylinder heads they were originally in a 1985-1989 454 out of a pickup. They were suppose to be redone not long ago, but the engine

Parts & Accessories - Mott, ND

$250

2024-09-06 22:50:20

6 Photos

Toyota engine from '97 Carola engine swap. Lots of parts to use. Was told it made

valve noise, possibly bent one. It ran when I pulled it. 1.6 liter Front main gasket I didn't use included. $50 Could

Parts & Accessories - Dickinson, ND

$50

2024-09-05 20:49:35

350 chevrolet chevy sbc crank crankshaft

good never cut polish it and install it is a cast piece

Parts & Accessories - Beulah, ND

$50 OBO

2024-09-03 08:01:31

Honda remaned engine...ready to install!!!

Early 80's Honda engine.It is a completely remaned.Engine has all new internal parts.It also has a new cylinder head.Its complete with everything on it.Also have the clutch,alternator,starter, and

Parts & Accessories - New England, ND

$750

2024-09-03 08:01:18

MASTER CYLINDER FOR A LATE 70'S DATSUN PICKUP.

Parts & Accessories - New England, ND

2003 Mach 1 4.6l 4V 60894 miles!

2024-08-22 13:20:28

10 Photos

Comes with Ecu, Maf sensor, and all radiator hoses seen in pictures. The engine is from an 03 Mach 1 that was wrecked. I purchased the car with the intentions

Parts & Accessories - Dunn Center, ND

$6,000 OBO

2024-08-22 00:24:43

5 Photos

Ford Mustang 4.6L 4v Parts

I'm selling a couple of parts for 4.6L 4v's to purchase a truck by the end of June. I'm in Dunn Center, ND and I'm willing to ship most of the parts. Everything is obo. Haltech Nexus R3 VCU w/8'

Parts & Accessories - Dunn Center, ND

2024-08-19 17:50:21

Parting out 1999 F-350 Everything except engine, pcm, idm and wiring harness is a

Parting out 1999 F-350Everything except engine, pcm, idm and wiring harness is available let me know what you need!

Parts & Accessories - Halliday, ND

2024-08-12 00:09:58

FOR SALE: MID 70'S 250 CHEVY 6 CYLINDER ENGINE. RUNS GOOD. HAS NEW ELECTRONIC DIST

RIBUTOR, CARB, AND POWER STEERING PUMP. IF INTERESTED, PLEASE TEXT, E-MAIL OR CALL. $400. THANK YOU! WILLING TO TRADE

Parts & Accessories - New Salem, ND

$400

2024-08-11 23:23:12

8 Photos

1999 GT Roller, 4.6L 4v Engine & 5 Speed Trans.

I will make a package deal to anyone who wants everything of 10k. 1999 Ford Mustang GT Roller for $7.5k. This Mustang needs work but has a lot of history to her. She was red and was the cover car

Parts & Accessories - Dunn Center, ND

$10,000

2024-08-11 23:09:52

10 Photos

Ford Mustang Cobra Short Block

03/04 Ford Mustang Cobra Block with parts to assemble a built short block. Machined .020 over by L&M Engines with balanced rotating assembly. Comes with Eagle Crank, Eagle Rods, Diamond L&M pistons,

Parts & Accessories - Dunn Center, ND

$4,500

2024-08-05 09:01:16

Came off of a running engine. 1.72 intake valve 1.5 exhaust valve. No accessory holes in the front of the casting. $500 obo. Call Adam 426-7947

283 power pack heads

Parts & Accessories - Glen Ullin, ND

Looking for 73-80 squarebody tilt column

2024-07-16 08:53:10

Looking for 73-80 chevy squarebody tilt steering column for a floor shifted manual. Doesn't need to be perfect just needs to be useable/rebuildable. I don't want to hear anything about EBAY

Parts & Accessories - Dickinson, ND

2024-07-16 00:14:00

AMC 401 rebuilt heads very little run time at all on them.

AMC 401 rebuilt complete heads and intake. Very very little run time at all on them. From a High Performance AMX Javelin. Bought it all rebuilt but going to build the engine up a different way. Everything

Parts & Accessories - Dickinson, ND

$1,000 OBO

2024-07-02 23:20:55

1990 K1500 Front Drive Shaft Chevy GM

Used drive shaft from 1990 Chevy K1500 with 700r4 and 241 C transfer case. Splines have some play but not bad. U-joints feel good. Cash only located in

Parts & Accessories - Hazen, ND

$100

2024-07-02 13:38:07

Early 90s toyota transfercase. 2 avaliable both working condition. Around 200k

miles on both. Went gear drive and no longer need.

Parts & Accessories - Belfield, ND

$100

2024-06-11 11:52:09

Vintage VW parts for sale: Clutch parts

Vintage VW parts for sale: I have a brand new flywheel, a pressure plate, a throw out bearing, and a clutch disc to fit your Volkswagen of yesteryear. The flywheel -- 200 mm -- is lightened which

Parts & Accessories - Dickinson, ND

$75

2024-05-17 00:03:32

10 Photos

400 350 327 SBC Small Block Chevy Blocks

Various engine blocks, heads, and cranks. Located in Hazen ND, cash only. Will load if you send shipper if wanted. I've used U-ship before with good results. 350

Parts & Accessories - Hazen, ND

2024-05-02 13:11:59

It is brand new, never been used on a running engine. It was put on a stroker motor and it isn't clearances for it so the crankshaft would come around and tap it. I don't know

Chrome oil pan for SBC

Parts & Accessories - Carson, ND

Mazda 6 TCU - transmission control unit L3R1

2024-04-27 00:58:38

5 Photos

for Automatic Transmissions. Brand New from Mazda Fits: 2007-2015 Mazda 6 2006-2015 Ford Focus Many more years & models Many automatic transmission

Parts & Accessories - Hebron, ND

$199

2024-04-06 11:11:59

Brand new SBC stock camshaft

Brand New camshaft still in box( actually I have two) it is the stock cam for every SBC Chevy, especially 350's, from 1967-1996 no lifters just cams, willing to trade

Parts & Accessories - Carson, ND

I have the cross members, torsion bars, axles, driveshafts, sway bar, steering gear, a-frames(upper and lower), brake calipers, front differential, transfer case and transmission,

2024-04-06 11:09:43

4 Photos

1991 k3500 parts

Parts & Accessories - Carson, ND