2018 Yar-Craft 219 TFX / 350 Verado Loaded / Low Hrs / Immaculate Condition - SALE PENDING PICKUP

350 Mercury Verado (276 Hours) / 22.5P Bravo FS worked by Marks High Performance Propeller (Mark Croxton)

Mercury 15 EFI Pro-kicker (likely under 100 hours) - Warrantied thought 12/21/2024.

Aluminum Tandem Trailer Upgrade / Led Lights / Stainless hardware / Vault hubs / Front Step.

Bob Machine Extreme Hydraulic Jack Plate

Zip-Wake SC300 Dynamic Trim Control System

3 Humminbird Helix 10s (2 Gen 3s & 1 Gen 2) / Humminbird 5 port network hub / glassed in 2d transducer / side imaging / mega-live compatible on 2 helixs / WILL NOT come with mega live pole or transducer. Everything networked along with trolling motor

Balzout Sonar Mounts for Bow Unit and Console Unit

112lb 36V Minn Kota Ulterra BT I-Link Trolling Motor on Quick Release Plate & Rail Mounted Ram Stabilizer.

Front 36" Rails / Rear 50" Rails

6 Folbe Advantage Rail Mounted Rod Holders / 2 Rod Holder Extensions

(2) Front Captain Seats both on AirWave Pedestals / (2) Two Rear Pedestal Seats on Slide Lock Pedestals / Removable Rear Bench Seat / Wash-down pump System / snap-in cockpit carpet / Aqua-traction in bow / snap cover for below windshield to keep wind out of cockpit on those cold days / factory tarp / Attwood motor covers / keel guard / lots of little stuff that didn't come from the factory like extra cup holders, limiter straps on compartment lids, a snap strap for the windshield, etc.

Upgraded Kicker BT Stereo with additional Bow Speakers and remote head unit in bow so radio can be controlled from bow or at console.

(3) Three 2-year old interstate lead acid deep cycle trolling batteries

(2) Two 1-year old Interstate Cl.31 AGM House & Starting Batteries (biggest and best made by Interstate - Over $700 new)

3 bank & 2 bank On-Board Chargers with cords routed to single plug location at motor

350 Verado had complete 300 Hour Maintenance completed over the winter including Serpentine Belt, Plugs, Oil & Filter, Fuel Filter, Fuel Water Separator Filter, etc. Kicker Motor also fully serviced.

Boat was a Yar-Craft photo boat used for their brochures and promotional materials in 2018.This boat was purchased through North Country Marine in Garrison, ND. I have all of the original boat documentation, build photos, and promotional photos of the boat. The is the second Yar-Craft photo boat I've owned.

The boat has been maintained with an open checkbook maintenance policy. Always had yearly oil, lower unit, and compete filter changes on the engines whether they needed it or not. This has been far and way my favorite boat of the last 4. I was planning to run it one more season but my new 2024 219TFX that I ordered is available for early delivery. I am extremely picky with how I treat and maintain my equipment. I do not allow shoes in my boats, socks only with few exceptions! Boat was wiped down at the ramp after every outing. Winter storage in a clean heated shop. Never ran as a guide boat or on the tournament trail. We have had a seasonal camp site or cabin during my entire ownership so trailer and boat have very few trailered miles. Just to avoid the question, It'll run 63-66mph depending on load and atmospheric conditions. You'll be hard pressed to find another 2018 as clean, well-cared for, meticulously maintained, or loaded. References available.